This damper is designed to face structure borne noise (engine compartments, cabs, bodyshells,….).
Its limited thickness ease it’s installation in confined areas.
Structural damping systems
This damper is made of an high damping material bonded on an aluminium plate.
A self adhesive layer on the elastomer to ease the installation.
This product will reduce vibrations and noise.
The damping is due to the shearing of the high damping layer.
Download PDF catalog
Related products
“Sandwich” Mounting
It consists of one or more layers of elastomer between two metal reinforcements.
The SANDWICH mounting comprises one or more layers of elastomer bonded to flat, parallel metallic plates. These mountings may be cylindrical or rectangular. They are designed to withstand very high compressive loads. The range of mechanical characteristics is governed by the hardness of the rubber and the number of intermediate metallic plates.
These mountings can support compression from 20 to 100 bars.
The metal plates usually receive a phosphate anti-corrosion treatment.
The elastomer is polychloroprene which provides a high resistance to atmospheric exposure.
Download PDF catalog
Triaxdyn
Comprises two elastomers which are assembled into a casting and pre-loaded.
This anti-vibration mounting comprises two elastomers which are assembled into a casting and pre-loaded.
The mounting is designed to offer:
– a large deflection (in axial),
– different stiffness in three axis,
– built-in stops to limit movement in all directions.
Note: The mount body can be modified to offer alternative interface dimensions providing the internal interface with the elastomer is maintained.
Download PDF catalog
S.C. Mounting
The S.C. mounting comprises an annular section bonded between the inner tube.
The S.C. mounting comprises an annular section bonded between the inner tube and outer housing.
The outer housing has a mounting flange (4 different types).
Download PDF catalog
Disc drive suspensions
A silicone (VHDS) elastomer with a bonded metal insert.
A silicone (VHDS) elastomer with a bonded metal insert. The legs have tangs which enable each leg to be pulled through mounting holes in the equipment. The suspended component can then be attached with an M3 screw through the insert. The tangs can be cut off after insertion.