The BECA mounting comprises one piece elastomer bonded to a top and bottom plate.
– Top plate: smooth or threaded (welded nut) hole.
– Bottom plate: Fixing lugs or direct bearing on the ground.
– Bonded rubber.
– Domed rubber ring.
– Anti-slip bead or grooved anti-slip sole.
– Removable protective top cover: protects the rubber and distributes the load.
The design of the BECA mounting gives the following basic characteristics:
– Transverse elasticity approximately the same as the axial elasticity(equi-frequency).
– Rubber works in compression.
– Progressive buffer against shocks or accidental overload.
– Anti-slip (may be placed directly on the ground).
SLM pneumatic mounts are made from synthetic rubber and are laterally reinforced with steel springs. The base plate is bored with 4 smooth holes to allow a possible fixing on the ground and the valve allows to inflate the mount in the same way as an automobile tyre.
– Elastomer body (temperature range -30ºC to +180ºC) resitant. To oils, te majority of solvents and natural ageing.
– The top and bottom plates are available in both steel and aluminium.
The STABIFLEX mounting comprises a conical rubber section bonded between inner and outer metal parts.
– Centre axis with threaded hole.
– Square (4 holes) or diamond base (2 holes) with clearance hole.
– Bonded natural rubber, anti-slip bead.
– Cup to protect the rubber and distribute the load.
The S.C. mounting comprises an annular section bonded between the inner tube and outer housing.
The outer housing has a mounting flange (4 different types).
A silicone (VHDS) elastomer with a bonded metal insert. The legs have tangs which enable each leg to be pulled through mounting holes in the equipment. The suspended component can then be attached with an M3 screw through the insert. The tangs can be cut off after insertion.
