Vibration mounting with fixing for heavy loads.
Other mounting systems
Vibration mounting with fixing for heavy loads.
Download PDF catalog
Related products
Radiaflex®
The work in shear of these plots lends itself very well to the vibratory isolation.
– Metalwork: Mild steel, plated.
– Natural rubber, bonded, cylindrically shaped.
– Welded fixings: 5 styles (single sided threaded stud, single sided threaded hole, double threaded stud, double threaded holes, combination fixing).
In Europe, we often use different screw standards than our french standard.To better satisfy this need, Paulstra has created a new range TRadiaflex Europe. This range is available with the 4 usual welded fixings and with a new fixing: the threaded hole stop.
Download PDF catalog
Elastomer plates E3PEPL
These sheets may be used for anti-vibration mountings for equipment.
VIBRACHOC has a large number of molded parts but in some cases: prototypes, unknown specifications, it is often convenient to determine the suspensions by cutting the plates into pieces and gluing them.
Download PDF catalog
Paulstradyn®
Anti-vibration decoupling for fixed equipment.
– Better than 90% isolation at 1.500 rpm(25 Hz).
– Constant height over wide load range.
– Stabilised characteristics during Service Life.
– Simple to fit.
– 400 hours protection against salt spray*.
– Design.
Download PDF catalog
Cupmount
Está formado por un anillo de caucho adherido a dos armaduras metálicas.
The CUPMOUNT is made of rubber bonded to two metal reinforcements of truncated form.
– Interior reinforcement with tapped hole.
– External reinforcements with square base (4 holes).