Vibration mounting with fixing for heavy loads.
Other mounting systems
Vibration mounting with fixing for heavy loads.
Download PDF catalog
Related products
Elastomer moulded parts
These parts are usually supplied in VHDS.
These parts are usually supplied in VHDS (very high density silicone) rubber and the full reference should include:
– the letter S,
– the appropriate grade which corresponds:
– to the youngs modulus of the rubber under static compression in accordance with ASTM D945 (ref. 33 to 77),
– or to the stiffness measured on a part (ref. 16 to 25).
Download PDF catalog
Paulstradyn®
Anti-vibration decoupling for fixed equipment.
– Better than 90% isolation at 1.500 rpm(25 Hz).
– Constant height over wide load range.
– Stabilised characteristics during Service Life.
– Simple to fit.
– 400 hours protection against salt spray*.
– Design.
Download PDF catalog
Disc drive suspensions
A silicone (VHDS) elastomer with a bonded metal insert.
A silicone (VHDS) elastomer with a bonded metal insert. The legs have tangs which enable each leg to be pulled through mounting holes in the equipment. The suspended component can then be attached with an M3 screw through the insert. The tangs can be cut off after insertion.
Triaxdyn
Comprises two elastomers which are assembled into a casting and pre-loaded.
This anti-vibration mounting comprises two elastomers which are assembled into a casting and pre-loaded.
The mounting is designed to offer:
– a large deflection (in axial),
– different stiffness in three axis,
– built-in stops to limit movement in all directions.
Note: The mount body can be modified to offer alternative interface dimensions providing the internal interface with the elastomer is maintained.