Various uses: machine vibration mounts, mounting blocks, stops docks…
Supports and bump stops
Rubber blocks of various shapes allowing the absorption of shock, vibration or serving as stops limit.
Download PDF catalog
Related products
Pneumatic Mounts SLM
It consists of a thick chamber of synthetic rubber.
SLM pneumatic mounts are made from synthetic rubber and are laterally reinforced with steel springs. The base plate is bored with 4 smooth holes to allow a possible fixing on the ground and the valve allows to inflate the mount in the same way as an automobile tyre.
– Elastomer body (temperature range -30ºC to +180ºC) resitant. To oils, te majority of solvents and natural ageing.
– The top and bottom plates are available in both steel and aluminium.
Download PDF catalog
Stabiflex
It is formed by a rubber ring attached to two metal reinforcements.
The STABIFLEX mounting comprises a conical rubber section bonded between inner and outer metal parts.
– Centre axis with threaded hole.
– Square (4 holes) or diamond base (2 holes) with clearance hole.
– Bonded natural rubber, anti-slip bead.
– Cup to protect the rubber and distribute the load.
Download PDF catalog
Minifix®
Comprises an elastomer pad with an anti-slipridged surface.
The MINIFIX mounting comprises an elastomer pad with an anti-slipridged surface and a threaded stud allowing accurate height adjustment of equipment. Made in two hardnesses (50 and 80 Sh) the MINIFIX mounting is perfectly suited to a variety of applications and is delivered complete with fixing nuts and washers. MINIFIX mounting nuts and screws are made of steel or stainless steel.
Download PDF catalog
Paulstradyn®
Anti-vibration decoupling for fixed equipment.
– Better than 90% isolation at 1.500 rpm(25 Hz).
– Constant height over wide load range.
– Stabilised characteristics during Service Life.
– Simple to fit.
– 400 hours protection against salt spray*.
– Design.