Vibration and noise isolation systems.
This range of mounts has one or two steel mounting plates depending on the model, one or several high strength steel springs, 2 light alloy rings and a stainless steel wire cushion in each spring.
All steel parts are painted.
These very low frequency isolators (down to 3 Hz) can be used to mount machine rotating at speeds over 450 rpm, vibrators and impact machines, achieving an attenuation of about 95%.
They are all metal and can be used outdoors or in the harshest conditions.
As they do not creep, their life time may be the same as that of the machine they are used to mount.
A metal cushion inside each spring increases the damping factor and limits the amplification at the natural frequency.
VE isolators have a cylindrical stainless steel spring, a galvanized body, an elastomer noise reduction guide and steel rings or studs depending on the model.
The VE112 series has a steel cushion inside the spring.
These medium frequency shock absorbers with multiracial and insensitive to external temperatures characteristics are suitable form limited places. They assure efficient protection of small equipment (electronic or electromechanical) in high frequency vibrating environments (50-3000 Hz). They can be used as mountings or stabilisers.
Anti-vibration mount available with a constant natural frequency over a wide load range.
Cast iron base and levelling device.
Conical wire mesh cushion, capable of narrying lateral loads.
V47D version has a stack of two cushions with a cast iron separating cup.
V47T and V47Q have three and four metal cushions respectively.
A single acting telescopic anti-vibration manufactured with a helicoil spring and stainless steel woven cushion. Protection, paint.