ISODYNE can be used to suspend lightweight equipment in a vertical plane.
ISODYNE®
The ISODYNE mounting comprises two half mountings joined together.
Download PDF catalog
Related products
Triaxdyn
Read more
Comprises two elastomers which are assembled into a casting and pre-loaded.
This anti-vibration mounting comprises two elastomers which are assembled into a casting and pre-loaded.
The mounting is designed to offer:
– a large deflection (in axial),
– different stiffness in three axis,
– built-in stops to limit movement in all directions.
Note: The mount body can be modified to offer alternative interface dimensions providing the internal interface with the elastomer is maintained.
Download PDF catalog
Elastomer moulded parts
Read more
These parts are usually supplied in VHDS.
These parts are usually supplied in VHDS (very high density silicone) rubber and the full reference should include:
– the letter S,
– the appropriate grade which corresponds:
– to the youngs modulus of the rubber under static compression in accordance with ASTM D945 (ref. 33 to 77),
– or to the stiffness measured on a part (ref. 16 to 25).
Download PDF catalog
Paulstradyn®
Read more
Anti-vibration decoupling for fixed equipment.
– Better than 90% isolation at 1.500 rpm(25 Hz).
– Constant height over wide load range.
– Stabilised characteristics during Service Life.
– Simple to fit.
– 400 hours protection against salt spray*.
– Design.
Download PDF catalog
Minifix®
Read more
Comprises an elastomer pad with an anti-slipridged surface.
The MINIFIX mounting comprises an elastomer pad with an anti-slipridged surface and a threaded stud allowing accurate height adjustment of equipment. Made in two hardnesses (50 and 80 Sh) the MINIFIX mounting is perfectly suited to a variety of applications and is delivered complete with fixing nuts and washers. MINIFIX mounting nuts and screws are made of steel or stainless steel.