Protection of electrical, electronic and mechanical equipment on board transport aircraft, industry, etc.
MV-7000
Metal shock absorber working in compression and adding a limit switch.
– Shroud, cup and base in light alloy AG3. Satin finished.
– Stainless steel 18/8 springs.
– Weight (aprox): 15-20 gr
Download PDF catalog
Related products
V164 / V168
The V164 and V168 dampers have a cover, an AG3 mounting plate andan AU4G shaft.
The V164 and V168 dampers have a cover, an AG3 mounting plate andan AU4G shaft. The assembly is chromatised.
The upper and lower stainless steel cushions are the resilient elements of the mounting. It has four Ø 8 mounting holes on the mounting plate and one M10 tapped hole on upper cover.
Download PDF catalog
VSP-392
Metal shock absorber, low frequency, with semi-elastic retaining.
Metal shock absorber, low frequency, with semi-elastic retaining divide by means of metal mesh.
Download PDF catalog
V47 / V47D / V47T / V47Q
Anti-vibration mount available with a constant natural frequency over a wide load range.
Anti-vibration mount available with a constant natural frequency over a wide load range.
Cast iron base and levelling device.
Conical wire mesh cushion, capable of narrying lateral loads.
V47D version has a stack of two cushions with a cast iron separating cup.
V47T and V47Q have three and four metal cushions respectively.
Download PDF catalog
VIBRAFLOT 357 – 961
VIBRAFLOT® is an antivibration system.
VIBRAFLOT® is an antivibration system consisting of the following elements:
– metallic box containing a low frequency spring;
– elastomer sheet to isolate high frequencies;
– system to fift the floating floor and set its height.