These multi-axis low frequency dampers have been specially designed to protect electrical or electronic racks and marine or road transport generator sets (on board or not). They are cone-shaped to absorb considerable displacement and shocks.
Vibmar
The VIBMAR series has a base plate with two or four mounting holes and a tapped steel core.
The elastomer is bonded to the steel.
E1N104 and E1N106 versions have a conical spring embedded in the rubber.
Environmental protection is provided by painting the metal parts and by coating the elastomer with an ozone resistant compound.
Download PDF catalog
Related products
Stops
Elastic stops are quiet and avoid hammering and deterioration of equipment.
There are several types of stops:
– Cylindrical or DIABOLO stops.
– Conical progressive stops.
– LEVAFLEX progressive stops with central cavity.
– EVIDGOM stops.
Download PDF catalog
Pneumatic Mounts SLM
It consists of a thick chamber of synthetic rubber.
SLM pneumatic mounts are made from synthetic rubber and are laterally reinforced with steel springs. The base plate is bored with 4 smooth holes to allow a possible fixing on the ground and the valve allows to inflate the mount in the same way as an automobile tyre.
– Elastomer body (temperature range -30ºC to +180ºC) resitant. To oils, te majority of solvents and natural ageing.
– The top and bottom plates are available in both steel and aluminium.
Download PDF catalog
Triaxdyn
Comprises two elastomers which are assembled into a casting and pre-loaded.
This anti-vibration mounting comprises two elastomers which are assembled into a casting and pre-loaded.
The mounting is designed to offer:
– a large deflection (in axial),
– different stiffness in three axis,
– built-in stops to limit movement in all directions.
Note: The mount body can be modified to offer alternative interface dimensions providing the internal interface with the elastomer is maintained.
Download PDF catalog
Elastomer plates E3PEPL
These sheets may be used for anti-vibration mountings for equipment.
VIBRACHOC has a large number of molded parts but in some cases: prototypes, unknown specifications, it is often convenient to determine the suspensions by cutting the plates into pieces and gluing them.