Protecting electronic equipment, navigation equipment, instrument panels, measuring instruments, control panels on aircraft, road vehicles and railway trains.
E1E21 / E1E22 / E1E23
VHDS elastomer.
Flange and shaft in 18/8 stainless steel.
Two Ø K fail safe rings must be provided.
Download PDF catalog
Related products
Pneumatic Mounts SLM
Read more
It consists of a thick chamber of synthetic rubber.
SLM pneumatic mounts are made from synthetic rubber and are laterally reinforced with steel springs. The base plate is bored with 4 smooth holes to allow a possible fixing on the ground and the valve allows to inflate the mount in the same way as an automobile tyre.
– Elastomer body (temperature range -30ºC to +180ºC) resitant. To oils, te majority of solvents and natural ageing.
– The top and bottom plates are available in both steel and aluminium.
Download PDF catalog
S.T.C.
Read more
The S.T.C. mounting comprises a rubber ring bonded to a central tube.
The S.T.C. mounting comprises a rubber ring bonded to a central tube.
– Inner tube: mild steel.
– Bonded rubber in the form of a ring at the top with a collar below which is used for fixing.
Download PDF catalog
Paulstradyn®
Read more
Anti-vibration decoupling for fixed equipment.
– Better than 90% isolation at 1.500 rpm(25 Hz).
– Constant height over wide load range.
– Stabilised characteristics during Service Life.
– Simple to fit.
– 400 hours protection against salt spray*.
– Design.
Download PDF catalog
Elastomer moulded parts
Read more
These parts are usually supplied in VHDS.
These parts are usually supplied in VHDS (very high density silicone) rubber and the full reference should include:
– the letter S,
– the appropriate grade which corresponds:
– to the youngs modulus of the rubber under static compression in accordance with ASTM D945 (ref. 33 to 77),
– or to the stiffness measured on a part (ref. 16 to 25).