A load range of between 20 to 5000 kg, depending on the mounting configuration and shock specification.
Flexible mountings for high loads MN 10 – MN 15
– Vertical own frequencies under nominal loads of 5 to 7 Hz.
– Own lateral frequencies under nominal loads of 3 to 6 Hz.
– Stop after 10 mm of displacement. Maximum force on the top of 30 g
Download PDF catalog
Related products
Flexible mountings for low loads MN 50
They allow to limit the reactions at the moment of the shock.
The permitted deflection (40 to 50 mm) of the suspended mass in relation to the mounting base limits reaction under shock.No efficient vibration protection is offerred during shock.
Download PDF catalog
Flexible mountings for low loads MN 75 composite
They ensure a low level of vibratory transmission in a broad frequency band.
These mountings were developed to handle small loads under large deflection (75 mm) and provide a low vibration transmission over a wide frequency range (up to 500 Hz).
The system developed provides this dual function effectively and without compromise.
Download PDF catalog
Laminated mountings
These assemblies can withstand high compression loads.
These assemblies can withstand high compression loads (along Oz): up to1,000 tons/sq.meter.
They can absorb shear deformation (along Ox and Oy) of 50 to 100% of their height.
Cylindrical or annular type assemblies can also withstand torsional displacement around axis Oz.
In rotation around axes Oy and Ox, these mountings enable angular or low amplitude rotation errors (approximately 1°).
Download PDF catalog
Strafluid Hydraulic mountings
A hydraulic suspension can at the same time provide a low frequency damping function.
The progress in motor vehicle design and increased demand for comfort both in terms of vibration and sound-proofing has resulted inincreasingly demanding specifications for suspension systems.
PAULSTRA hydraulic mountings use an elastomer support device combined with an hydraulic system. The hydraulic system acts differentially and specifically in relation to the frequency range and the type of vibrational excitation incurred.
These mountings, due to a total integration of all components, are still compatible with standard sizes and are as easy to fit as conventional mountings.