Own frequency: 9 to 15 Hz
S.C.P. mounting
Anti-vibration mount for stationary equipment with protective cover.
Download PDF catalog
Related products
Paulstradyn®
Anti-vibration decoupling for fixed equipment.
– Better than 90% isolation at 1.500 rpm(25 Hz).
– Constant height over wide load range.
– Stabilised characteristics during Service Life.
– Simple to fit.
– 400 hours protection against salt spray*.
– Design.
Download PDF catalog
Triaxdyn
Comprises two elastomers which are assembled into a casting and pre-loaded.
This anti-vibration mounting comprises two elastomers which are assembled into a casting and pre-loaded.
The mounting is designed to offer:
– a large deflection (in axial),
– different stiffness in three axis,
– built-in stops to limit movement in all directions.
Note: The mount body can be modified to offer alternative interface dimensions providing the internal interface with the elastomer is maintained.
Download PDF catalog
Pneumatic Mounts SLM
It consists of a thick chamber of synthetic rubber.
SLM pneumatic mounts are made from synthetic rubber and are laterally reinforced with steel springs. The base plate is bored with 4 smooth holes to allow a possible fixing on the ground and the valve allows to inflate the mount in the same way as an automobile tyre.
– Elastomer body (temperature range -30ºC to +180ºC) resitant. To oils, te majority of solvents and natural ageing.
– The top and bottom plates are available in both steel and aluminium.
Download PDF catalog
Engine mountings
Is made of one conical elastomeric elementen closed in a cast iron assembly.
This engine mounting is made of one conical elastomeric elementen closed in a cast iron assembly. A built-in adjustable stop limits the vertical and lateral displacement during shock. This mount is available in four different alternatives depending on the type of upper fixing needed.
It can be supplied with or without levelling system and with a threaded hole or a threaded stud.