ISODYNE can be used to suspend lightweight equipment in a vertical plane.
ISODYNE®
The ISODYNE mounting comprises two half mountings joined together.
Download PDF catalog
Related products
Elastomer plates E3PEPL
These sheets may be used for anti-vibration mountings for equipment.
VIBRACHOC has a large number of molded parts but in some cases: prototypes, unknown specifications, it is often convenient to determine the suspensions by cutting the plates into pieces and gluing them.
Download PDF catalog
Supports and bump stops
Rubber blocks allowing the absorption of shock, vibration or serving as stops limit.
Rubber blocks of various shapes allowing the absorption of shock, vibration or serving as stops limit.
Download PDF catalog
Paulstradyn®
Anti-vibration decoupling for fixed equipment.
– Better than 90% isolation at 1.500 rpm(25 Hz).
– Constant height over wide load range.
– Stabilised characteristics during Service Life.
– Simple to fit.
– 400 hours protection against salt spray*.
– Design.
Download PDF catalog
Disc drive suspensions
A silicone (VHDS) elastomer with a bonded metal insert.
A silicone (VHDS) elastomer with a bonded metal insert. The legs have tangs which enable each leg to be pulled through mounting holes in the equipment. The suspended component can then be attached with an M3 screw through the insert. The tangs can be cut off after insertion.