ISOFLEX mountings may be used for suspending any small measuring or recording equipment, mobile equipment, machine tool controls.
ISOFLEX®
The ISOFLEX mounting comprises two concentric metallic parts joined by a bonded, perforated rubber ring.
Download PDF catalog
Related products
Evidgom®
The EVIDGOM® support can be assimilated to two thick conical membranes.
The EVIDGOM mounting is formed from two thick conical membranes, joined at their bases to create a highly elastic mounting.
There are three variations:
– All rubber EVIDGOM.
– EVIDGOM with bonded fixing.
– EVIDGOM with a diamond or square mounting plate (fixing plate supplied as a separate kit).
Download PDF catalog
Paulstradyn®
Anti-vibration decoupling for fixed equipment.
– Better than 90% isolation at 1.500 rpm(25 Hz).
– Constant height over wide load range.
– Stabilised characteristics during Service Life.
– Simple to fit.
– 400 hours protection against salt spray*.
– Design.
Download PDF catalog
Disc drive suspensions
A silicone (VHDS) elastomer with a bonded metal insert.
A silicone (VHDS) elastomer with a bonded metal insert. The legs have tangs which enable each leg to be pulled through mounting holes in the equipment. The suspended component can then be attached with an M3 screw through the insert. The tangs can be cut off after insertion.
“Sandwich” Mounting
It consists of one or more layers of elastomer between two metal reinforcements.
The SANDWICH mounting comprises one or more layers of elastomer bonded to flat, parallel metallic plates. These mountings may be cylindrical or rectangular. They are designed to withstand very high compressive loads. The range of mechanical characteristics is governed by the hardness of the rubber and the number of intermediate metallic plates.
These mountings can support compression from 20 to 100 bars.
The metal plates usually receive a phosphate anti-corrosion treatment.
The elastomer is polychloroprene which provides a high resistance to atmospheric exposure.